Configure your Launcher device.
Connect over WebSerial to set up WiFi networks and, on boards with a resistive touchscreen, fine-tune the touch calibration — no firmware flashing required.
Connection status
Not connected. Click "Connect Device" and select your board's serial port.
Device
Launcher version
—
Device name
—
WiFi
Touchscreen calibration
This device reported a resistive touchscreen. Run the guided on-device wizard, adjust the raw calibration values below, or use the quick actions to mirror an axis or swap X/Y.
Device settings
Raw settings stored on the device. Saved WiFi networks and favorites are read fresh from the device right before saving and are never edited here.